Trina Storage introduced a new hybrid power product on Nov. 18, 2026 at RE+ 2026 in Las Vegas, combining gas-fired generation with the company's battery storage platforms under a single hybrid plant controller.

The Elementa Hybrid Genset is aimed at data center developers that need on-site power while grid interconnection is delayed, limited, or unavailable. The launch follows a preview of the solution at Data Center World Power in September.

Addressing the Limits of Each Technology Alone

The company framed the product as a response to a pairing of limitations. AI workloads can cause rapid and substantial fluctuations in power demand that gas generators alone may struggle to follow, according to Trina Storage.

Battery storage, meanwhile, responds quickly to those fluctuations but is not designed to supply energy through extended outages on its own.

By combining the two technologies, Elementa Hybrid Genset is positioned for AI data centers with demanding power requirements, particularly where grid capacity is constrained or workloads fluctuate rapidly.

How the System Is Built

The system consists of three main components.

Gas generation provides sustained power, using reciprocating engines rated up to 2.5 MW in modular configurations.

Trina Storage acts as the system integrator, while qualified engine partners supply the generation equipment.

The Elementa and Electra BESS solution provides rapid power response and grid-forming capabilities, with reference configurations based on 5 MW/10 MWh building blocks.

A hybrid plant controller coordinates all power sources in real time, and its scalable control architecture is designed to support applications ranging from 5 MW to 1 GW.

Three Control Technologies Coordinate the Resources

Elementa Hybrid Genset incorporates three core control technologies for coordinating power resources and responding to changing operating conditions.

Load Transient Sensing uses the power plant controller to predict changes in power demand and coordinate a rapid BESS response, allowing the system to accommodate swift load fluctuations before slower-responding power sources can adjust.

Hybrid Power Coordination dynamically coordinates power output between the BESS and gas generators. When a sudden load increase occurs, the BESS responds immediately while the gas generators gradually ramp up, enabling the two sources to balance their contributions as demand stabilizes.

Fault Isolation and Resilient Power Supply addresses failures. When a fault occurs, the control system identifies and isolates the affected equipment, while the BESS and remaining available gas generators respond to support critical loads and facilitate power restoration across the site.

According to the company, these capabilities help coordinate different power sources within one system, with the specific operating strategy depending on the project configuration and requirements.

Deployment Scenarios and Architecture Options

The solution supports four reference scenarios: grid-connected with backup generation, grid-constrained, bridge-to-grid, and off-grid.

Solar PV can also be integrated where appropriate.

Two system architectures are available. The Load Sensing architecture prioritizes cost efficiency and system performance, while the Double Conversion architecture provides full electrical isolation and enhanced power quality.

The choice between the two depends on the IT load profile and grid conditions at a given site.

Testing and Certification in Progress

Trina Storage says it continues to develop and validate the product through simulation, hardware-in-the-loop testing, and an integrated validation platform incorporating real power generation, conversion, and storage equipment.

Further testing of grid-forming functionality and hybrid control strategies is ongoing, alongside relevant certification activities.

Final system configurations and performance specifications will be assessed based on individual project requirements.

Project-Specific Configurations

The company describes the product as designed to accommodate different power requirements and grid conditions, from grid-connected sites seeking additional power flexibility to projects operating with limited or no grid access.

System architecture and equipment selection can be tailored to each project's load profile, site conditions, and operational requirements.

Trina Storage is currently engaging with data center developers and project partners to explore potential applications and develop project-specific configurations.

"AI data centers have demanding power requirements, particularly when grid capacity is constrained or workloads fluctuate rapidly. Elementa Hybrid Genset brings gas generation, battery storage, and hybrid controls together in one system architecture, designed to coordinate these resources according to project needs," said Eric Cao, Vice President of Trina North American PV and BESS Business.

With the launch, Trina Storage, which describes itself as a global leader in energy storage solutions, enters the growing field of hybrid power solutions for data centers where grid access cannot keep pace with demand.